Kingston HyperX Fury Desktop 4GB DDR3 1600MHZ DIMM RAM HX316C10FB/4 (BLACK)
RM178.00
- JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
- VDDQ = 1.5V (1.425V ~ 1.575V)
- 800MHz fCK for 1600Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 11, 10, 9, 8, 7, 6
- Programmable Additive Latency: 0, CL – 2, or CL – 1 clock
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
- Bi-directional Differential Data Strobe
- Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
- On Die Termination using ODT pin
- Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
- Asynchronous Reset
- Height 1.291” (32.80mm) w/heatsink, single sided (Double Sided 8GB) component
1 in stock
Kingston Desktop DDR3 RAM 1600Mhz
HyperX HX316C10FW/4 is a 512M x 64-bit (4GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module, based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:
HyperX HX316C10FW/8 is a 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8 memory module, based on sixteen 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V.
| Weight | 0.2 kg |
|---|---|
| Dimensions | 0.2 × 0.2 × 0.2 cm |
Be the first to review “Kingston HyperX Fury Desktop 4GB DDR3 1600MHZ DIMM RAM HX316C10FB/4 (BLACK)”
Related products
Out of stock
Sale!
Out of stock
Reviews
There are no reviews yet.